New Review Posted

[pHaestus]

Test system is working properly again and so here's another review:

Swiftech MCW6002-A Review (http://www.procooling.com/reviews/html/swiftech_mcw6002-a_waterblock_.php)

I think a few people have been eager to see this one. Perhaps wb designers can learn something from the tapered nozzle inlet? Oh, btw thanks again to BalefireX for making the graphs on the interactive wb comparison page :)

[LPorc]

From the review: "The most likely reason for that is that the tapered inlet nozzle on the 6002 isn't producing as high a water velocity for die area impingement as does the straight 3/8" tube."

Wouldn't a more likely reason be the less restricive outlet in the 6002? I'd like to see the 6002 with the same tapered tube used for the outlet with the restrictive end on the block side (same as the inlet).

[pHaestus]

I don't think the outlet restriction would have too much of an effect on the cooling ability; esp with a Socket A chip as the heat source. I could be wrong though.