sgossard34
06-26-2006, 05:41 PM
I just wanted to let everyone know i successfully upgraded the fan on my snap 2200. ( referring to my earlier post at http://forums.procooling.com/vbb/showthread.php?t=13241 )
The unit takes a 60x60x15mm fan. I bought this one from a seller on ebay and he does have more of them. The fan is perfect. Very nice air draw and movement. The holes match up perfectly with the ones on the snap unit. The only issue is the replacement fan comes with a 4 pin connector but you can just rig it up off the power supply and then into the hard drive. You will see if you buy one. Very easy setup and no extra work needed.
specs of new fan:
Model Number KD1206PHB1-4-86
Cubic Feet per Minute (CFM) 21
Decibels (dBA) 37.5
Revolutions Per Minute (RPM) 4300
Pressure (inch-H20) .18
Connector 4-Pin Pass through
Voltage 12v
seller link: http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=6829011904&ssPageName=MERC_VIC_RSCC_Pr4_PcY_BIN_Stores_IT
enjoy!
The unit takes a 60x60x15mm fan. I bought this one from a seller on ebay and he does have more of them. The fan is perfect. Very nice air draw and movement. The holes match up perfectly with the ones on the snap unit. The only issue is the replacement fan comes with a 4 pin connector but you can just rig it up off the power supply and then into the hard drive. You will see if you buy one. Very easy setup and no extra work needed.
specs of new fan:
Model Number KD1206PHB1-4-86
Cubic Feet per Minute (CFM) 21
Decibels (dBA) 37.5
Revolutions Per Minute (RPM) 4300
Pressure (inch-H20) .18
Connector 4-Pin Pass through
Voltage 12v
seller link: http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=6829011904&ssPageName=MERC_VIC_RSCC_Pr4_PcY_BIN_Stores_IT
enjoy!