View Full Version : lookin for Radiator with 1/2" or bigger inlets
ondaedg
04-30-2001, 05:26 PM
Anyone know of any? I would like to play around a little with flow rate, temperatures, and hose size a little. So if you know of one, drop me a line.
UnaClocker
04-30-2001, 07:51 PM
Heater cores come with fittings around that size. :)
Not sure about others, but I do know that OCWC sells BigMama with 1/2" by request.
Not sure if you're looking for something cheaper to play around with tho.
lorry12
05-11-2001, 03:07 PM
use an oil cooler from a small car or motorbike, they are easily adapted (once cleaned) and have approx 1/2" bore.
sharpbw
05-11-2001, 08:14 PM
Lots of pics and stuff here:
http://www.heatercore4u.com/
ondaedg
05-12-2001, 03:42 AM
thanks for the info guys. Bill, I was lookin at that site last nite. There has to be other heatercore sites online. The better the selection, the better for us.
lorry12
05-13-2001, 07:29 AM
just go to a scrap yard ( i believe they are called "junk yards" in the US ! :D )
you will find oil cooler on a motorbike or small car ( got mine from a mini !!)
good luck
FreakinCold
05-27-2001, 04:53 AM
Get a hayden 1401 and cut off the ends. They flare down to a 3/8 hose size but the tube is damn close to 1/2". If you cut it right, you'll have plenty of room for the hose clamps. Good luck with your w/c setup.
FrakinCold WWW.FreakinCold.com (http://WWW.FreakinCold.com)
vBulletin® v3.7.4, Copyright ©2000-2024, Jelsoft Enterprises Ltd.