how are these temps?
 

are these temps ok for water cooling? ok this is with tbird not an xp and also folding.

here is another with ahigher overclock and vcore

Depending on the equipment and the enviroment you are in I would say those are decent temps. What is the setup you are using?

I reckon those temps are quite good, but it might just be your diode thats out

actually it is aircooled using a duct. 120mm at one end and a delta 80 mm at the other. still getting stuff up to go watercooling. right now I'm short a pump and a block. this is what I plan on ehiem 1250, dangerden maze2, blackice rad, all using 1/2'' hose. I see alot of people putting down air cooling but it can be good if done right but watercooling is much better and I think I'm at the limits of aircooling.
I have all the stuff for my duron already except I need a heater core for it. don't want to use the blackice in that case b/c it's a much bigger case while the other is only a mid tower. plus the duron will be using only 3/8" hose and I have already modded the blackice with 1/2" fittings.
I would like to get under 35c under load with a room temp of 24c-25c

using air those temps are really good, what cfm are those fans? the loud ones?

the 120mm is a radio shack fan I'm not sure of cfm but I believe it's only 86cfm. (I would never recommend radio shacks fans a panaflo would be a better choose I have another system using a panaflo H1 without a fan on heatsink and it is very quiet) on the other end I have an 80mm delta 68cfm the funny thing is the fan are cancelling some of the noise or it is the duct b/c it sounds about the same as a swifty mc 462 with the delta's before I was using a 60mm instead of the 80mm and it was louder.