Duron 1300 Morgan unlock troubles
 

I have attached a picture of the layour of my bridges on this cpu. The main difference i noticed is that it has 5 L1 bridges.

I have tried pencil mod and it wouldnt boot (dead) cleaned it off and it worked fine.

Tried conductive pen trace ink with a pin tip, and still same thing.

is there something i am missing? i have unlocked my duron 950 no problem and it had 4 L1 bridges

any input would help thanks

AMD
Duron
DHD1300AMT1B
AHLCA0219APHW

I am going to post a revised pic with all the birdges in a while, and i also forgot that the lower right bridge labeled as L1 and a large red line is supposed to be L10 i think

Last I heard about the 1300 is that you have to CUT bridges to unlock it.

Which i'm kinda glad I gave it to my mom and got an XP1800 instead.

Well im not sure how that can be... since the birdges are all cut on this CPU i have.

But i read on a site about amd possibly removing pins to stop unlocking the multiplyer, I dont know if this is true.

Maybe someone here has some info on this i would appreciate it.

Found this on Overclocker's forum...I think this is what I was refering to.

Do you have a link to the article to which you are referring to? thanks

Not really an article...its someone's post on a forum.

http://forum.oc-forums.com/vb/showth...hreadid=137870

Ok thanks man

I see why there is troubles unlocking any cpu that uses a multiplyer over 12.5

i have tried the pin mod suggested in that forum link you gave above, but that didn't help.

I will try cutting the birdge but it is going to be a pain.