Fan placement problem
Here it goes. My fan, heatercore and shroud will be located at the top of my case....inside it. Because of some case configuration issues, I have no choice but to put the 120mm fan at the top then the shroud and finally the heatercore.
Should I push cool air from outside through the heatercore and into the case or pull the air from the case through the heatercore and then let it go outside the case? The reason I'm asking is that I know that normally you should pull the air but since it would be the air from inside the case (hotter) and not from outside the case I was wondering if I should push the air instead. Thx. |
yeah i push the air through my rad at the top of the case and i get decent temps. see the link below
ambient 19 idle 27 load 30 blx 1.53 tbird spir@l wb danner 500gph 1/2 inch tygon http://forums.procooling.com/vbb/sho...&threadid=3958 |
Hey.
I have a bix with a push/pull fan system on top of my case, works fine. It works like this : fan(push)->shroud(60mm)->bix->(10mm spacer) fan(pull). With the nexus controlling the fans, they're quiet enough.
I also have a 120mm fan intake, and most of the exaust is done through de rad. I think its the best cooling given my case (wich is isnt that good). However, i think it should work in either way (Mine or ambient's). |
All times are GMT -5. The time now is 07:14 PM. |
Powered by vBulletin® Version 3.7.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
(C) 2005 ProCooling.com If we in some way offend you, insult you or your people, screw your mom, beat up your dad, or poop on your porch... we're sorry... we were probably really drunk... Oh and dont steal our content bitches! Don't give us a reason to pee in your open car window this summer...