View Single Post
Unread 08-25-2005, 11:29 PM   #29
jaydee
Put up or Shut Up
 
jaydee's Avatar
 
Join Date: Dec 2001
Location: Spokane WA
Posts: 6,504
Default

I made this base a little over a year and a half ago simply to test my mill. I am kicking myself for not turning it into a block. One thing I am not to sure on (among many others) is how small the pins really need to be. The pins on this base are approx. 1/16" x 1/16". The pins on my Lemon Cu block has 1/8" x 1/8" pins and the pins on my R-Type block were a little less than 1/8". I plan on doing a lot of experimentation on this myself.

I wanted to tripple the pin count in the same area as this base but my mill just isn't up to the accuracy with a endmill. I will be seeking a slit saw attachment now that we see what can be done with one. With the mill I have been building on the side I think I can make some decent blocks with it.... Also have a few other ways of making pins...
Attached Images
File Type: jpg pingrid.jpg (73.8 KB, 79 views)
jaydee is offline   Reply With Quote