No. I meant 180 degrees as in the impingement nozzle itself. Kind of like a cresent moon without points. but tangent arcs instead.
But unlike picture below(didnt have time to change), I could cut it with a tapered end mill so that it is hyperbolic as mentioned above.
But for now, Id just like to be able to know how to calculate the area of the impingement nozzle as shown in the attachment, so that it creates the proper amount of impingement for a 1/2"NPT barb. Then Ill go from there.
Last edited by LiquidRulez; 02-03-2003 at 09:38 PM.
|