The inlet and nozzle are not to scale and are just for representational purposes only. The nozzle opening will be cut to accomodate for the barb itself, so it will be flush with the inner bore.
I considered using multiple smaller jets also. Just thought it would focus more of the impingement into the outside where its most important being designed that way. Also to avoid any dead spots in my design.
A hyperbolic cut in that nozzle design can be cut with a tapered end mill.
Ive concidered making the top plate thick enough to accomodate the threaded part, and taper it from the bottom of the threads to the end of the nozzle. Im trying to go about it as easy as possible to mill.
You got PM BEN
|