Pro/Forums - View Single Post

frenchnew · 06-28-2006, 07:50 PM

Dremel's Drill press attachement is useless with small drill bit (smaller then 1/16")

Specially the solid carbide kind as it has too much free play.

I learned the above the hard way tring to drill holes in a Printed circuit board I had just did. After drilling 8 holes , I had broken 12 drill bits.

You might want to try it, but I suggest that you buy the drll press attachement from a local dealer which would allow you to return it if you are not satisfied.

Best regards

frenchnew

06-28-2006, 07:50 PM	#18
frenchnew Cooling Neophyte Join Date: Aug 2003 Location: Canada Posts: 19	Re: DIY block performance Dremel's Drill press attachement is useless with small drill bit (smaller then 1/16") Specially the solid carbide kind as it has too much free play. I learned the above the hard way tring to drill holes in a Printed circuit board I had just did. After drilling 8 holes , I had broken 12 drill bits. You might want to try it, but I suggest that you buy the drll press attachement from a local dealer which would allow you to return it if you are not satisfied. Best regards frenchnew __________________ Sorry, gone to serve another customer.