Pro/Forums - View Single Post

PhoenixLover1 · 06-16-2010, 12:20 AM

I double checked that the voltage is getting to the mboard fine (5v on the red and 12 on the yellow).

I still also have two wires going to the mboard from the small power control switch board. I guess these are my only hope for an repairable scenario. A dark purple wire apparently outputs +4v, while the dark gray one seems to cycle 1.5v (to blink a [disconnected] Link/Drive activity LED?... i dunno).

06-16-2010, 12:20 AM	#55
PhoenixLover1 Cooling Neophyte Join Date: Jun 2010 Location: Oregon Posts: 6	Re: SNAP 4000 Power Supplies I double checked that the voltage is getting to the mboard fine (5v on the red and 12 on the yellow). I still also have two wires going to the mboard from the small power control switch board. I guess these are my only hope for an repairable scenario. A dark purple wire apparently outputs +4v, while the dark gray one seems to cycle 1.5v (to blink a [disconnected] Link/Drive activity LED?... i dunno).