View Single Post
Unread 07-21-2006, 05:17 PM   #2
mx
Cooling Neophyte
 
Join Date: Oct 2005
Location: Sweden
Posts: 73
Default Re: Final Peltier Setup, Suggestions Anyone?

Pump
I'd go with a DDC+ with top inlet (DIY, alphacool DDC-Ultra, Radiical turbo head) instead of a D5. It performs better, dumps less heat, has a lower soundlevel and it's smaller.

CPU block
Swiftech 5002-64T has an aluminum top which is bad in combination with copper, period! Maybe you could mod an Apogee, maybe convert it to Apogee-T with some parts from a Swiftech MCW-60T? Or just get a Danger Den Maze4-1.

Radiator
I'd go for ThermoChill instead of BI GT since it performs better. If it's too expensive I'd go with Swiftech/Cooltek or maybe Coolingworks instead.

Tank vs. fillport
I'd choose T-line + fillport over res any day. Maybe a delrin fillport from petras techshop or a delrin or brass from DangerDenStore.com? Make sure you get a big T-connection so you don't waste flow, can be found at mcmaster or vcore.dk. If you want a tank maybe alphacools mini tank is a less restrictive alternative?
mx is offline   Reply With Quote