Attached is the revisions I was going to do except the holes for the probes would have been 1/8". Is that something closer to what you suggest? I was already going to install 2 probes, were would a 3rd go? Also should the holes go into those steps or be drilled right into the pedestal itself?
This is also going to require a different thermometer than the one I have. It only exepts YSI 400, 500, and 700 series probes. Smallest one's I can find are 1/8". I hear the 500 series has smaller but I cannot find them anywhere.
So the list so far:
1) Thermometer with 1/16" or smaller tc's?
2) Differential Pressure transmitter (probably Rosemount 1151)
3) 1/2" magnetic flow tube flowmeter.
4) Redesigned die sim
|