Re: logical set 60000, error -1
How did you wipe all drives? Did you put them into pc and write 0's to all sectors?
The drive that is in bay 4 which is actually drive 3 because we start counting from 0, does have a bad or going bad sector.
I would check the debug log using the following cmd at least once a week and look for the following errors
command = i l p -1
error = DISK: req=0x515EC60 dev=0xc0003 fn=1 blk=0xA39AD70 sts=20
dev=0xc0003 = the last digit = drive# (0 - 3)
blk=0xA39AD70 = the block number.
It will take me a few minutes to explain the starting blocks, and will have some time available later today. sorry for delay on that.
Douglas Snap-Tech
|