Pro/Forums - View Single Post

V12|V12 · 07-03-2002, 04:46 AM

Yeah I'm thinking about going with design #2, for the fact that the water will be flowing in the direction that forces it through the pins, and I'm going to make them fit to the top of the copper end cap as much as possible... basically I'll just punch and drill the pin holes, then use some silver braze to meld them into the copper base plate... wish I had some thicker plates! 3mm ain't much, and stacking+brazing is a hassle!

I might order some metal stock online, but I've never seen any place that sells anything less than 3/4in thick...

Hope this works out, cause if so, then I'm going redo my current CPU block to the North Bridge Idea #2...

Thanks for the advice!

07-03-2002, 04:46 AM	#11
V12\|V12 Cooling Savant Join Date: May 2002 Location: Ohio-State! <--Money Hussle! SUCKS Posts: 292	Yeah I'm thinking about going with design #2, for the fact that the water will be flowing in the direction that forces it through the pins, and I'm going to make them fit to the top of the copper end cap as much as possible... basically I'll just punch and drill the pin holes, then use some silver braze to meld them into the copper base plate... wish I had some thicker plates! 3mm ain't much, and stacking+brazing is a hassle! I might order some metal stock online, but I've never seen any place that sells anything less than 3/4in thick... Hope this works out, cause if so, then I'm going redo my current CPU block to the North Bridge Idea #2... Thanks for the advice! __________________ XP 1600+ AGOIA-Y (GreenLabel, UNLOCKED!@/ NF7-S 2.0/ PC 2700 DDR 10.5*172FSB(1806/ 1991 high), Vcore 1.792...@84.95Watts --86' Chevette Heater Core --1/2" Vinyl tubes --Via1300-Stealth Mod(QUIET!) ---Home made copper-tube block ---PVC small internal res