Pro/Forums - View Single Post - The next evolution to cathar's microchannel design

hara · 01-12-2003, 01:56 PM

I assumed the core is all heating the same. I placed the thin base exactly on the centre because heat it is surrounded by heat. It's in the middle of the heat source. The reality is that half the area of the cpu core is L2 cache which doesn't produce much heat but anyways... I'll start researching where to machine it cause I'm sure it's a bitch.

I thought about a compination of thorns, mills and drill presses. What do you think?

01-12-2003, 01:56 PM	#25
hara Cooling Savant Join Date: Oct 2002 Location: Malta, Mediterranean Posts: 662	I assumed the core is all heating the same. I placed the thin base exactly on the centre because heat it is surrounded by heat. It's in the middle of the heat source. The reality is that half the area of the cpu core is L2 cache which doesn't produce much heat but anyways... I'll start researching where to machine it cause I'm sure it's a bitch. I thought about a compination of thorns, mills and drill presses. What do you think?