2nd thermochill 120.2 and swiftech 650 pump arrived monday and i have been hard at it.
I made a res out of some acrylic i aquired from an old customer that had some spyware problems that i sorted for them.
This was a failed first attempt as it leaked but i learned from my mistakes and make a 2nd one.
Here you can see the 2 rads in the lower part of the case along with the res in the 5 1/4 drive bays and pump. This is not how it will be plumed in.
I wanted to go res=pump=rads=cpu=gpu=chipset=res but the plumbing is a bit tight and i need to fit a bleed line in to the loop.
I did a test off res=pump=cpu=gpu=chipset=rads=res. will having the water going to the rads = res = pump = cpu be worse than res=pump=rads=cpu as it will be sitting in the res before the cpu instead of passing through the rads.
Next is to get the psu mounted in the top.
then i need to look at cuting the side panles and painting ect.