Re: Help with making new water block
please pass a link for a hole saw that you recomend... I have never seen one that can go as far as 4inches. The ones I have would go 8mm max.
Where can I get those xy table? I am dying to get my hands on something like that. Perhaps if I go easy, I can make fairly complex designs with such a tool. Will it fit any drill press?
I would use rubber sheets. I do not have a dremel.
Currently I have two Copper plates lying around. One is 4inch wide, 15inch long and 1 inch thick.
Other is 50mm wide, 6inch long and 1 inch thick.
Is there any 'in home' method to lap? These Cu plates have deep pits and using a sanding paper did not do the job (lapped for hours but...)
__________________
NOTE: Suggestions are based on my perceptive. I could be erroneous. Therefore, no one has the right to criticize an individual other than rephrasing and or expressing his own annotations on the subject matter itself.
|