Quote:
Originally posted by tex707
OK, jaydee....how about this impossible-to-machine version of your NB waterblock...???....
|
That is pretty damn cool! It is millable but not sure I can do it.
Quote:
Originally posted by tex707
Well...the difference between 1.65" and 1.67" is marginal....if you have just a little bit of play between the bolt and the holes in the motherboard, it could pass unnoticed.
Of course, I'll change my 3D motherboard model according to your measurements...
|
Yeah it souldn't matter. I am not sure which is to specs but I know mine works. The holes line up perfectly with the HS holes. Also note this is slightly different than the first block in the zip file. I had 2.38" diagnaly on it and this one is 2.33". I am concerned about the ASUS and ABIT board i got at home which these blocks are being built for. If this ASUS A7V333 has different specs it is almost a given the ASUS A7V8X-X has the same. If that is the case I will have some remodeling to do as the holes are much tighter... Will check it out later tonight when I get a chance.