Pro/Forums - View Single Post

morphling1 · 02-05-2002, 06:39 PM

Thanks,

First to Brad, ambient temp. was around 19-20°C , my radiator is doing great work, with this load it keeps water temp within 1°C above ambient.

EMC2, we're going to make 4mm Cu and AL block for production (I was wrong about base thickness of Cu&AL block, it is 6mm and not 5mm, I was pretty tired and made the mistake and did't see it). As for the water temp I measure it at the and of the 20min test of the first block and it was 19.6°C , and then rose to 20°C with second block and stay there through the whole test. The tip of the probe is definetly in the water, and I don't think insulation would help cos' the ambient is so close to water temp.
I will do another test when I get my replacement AXP overclock the hell out of it and made the test even better, learning from this test.

02-05-2002, 06:39 PM	#9
morphling1 Cooling Savant Join Date: Sep 2001 Location: Slovenia Posts: 468	Thanks, First to Brad, ambient temp. was around 19-20°C , my radiator is doing great work, with this load it keeps water temp within 1°C above ambient. EMC2, we're going to make 4mm Cu and AL block for production (I was wrong about base thickness of Cu&AL block, it is 6mm and not 5mm, I was pretty tired and made the mistake and did't see it). As for the water temp I measure it at the and of the 20min test of the first block and it was 19.6°C , and then rose to 20°C with second block and stay there through the whole test. The tip of the probe is definetly in the water, and I don't think insulation would help cos' the ambient is so close to water temp. I will do another test when I get my replacement AXP overclock the hell out of it and made the test even better, learning from this test.