It's not what I thought, I thought the water entered one side went down and connected through the lower 'join' and up the other side to exit. Do you think it gets good flow on both sides?...
My V~Chips get so hot I can't touch the plate!, even putting a fine~finned HS on that is the same size as the plate and 1inch high does'nt get rid of the heat, it just knocks abit of it off. At least I can keep my fingers on it now though
I though the caps' on the other side were gonna blow!!...
*Edit* I can't keep my pinkies on the strange little graphite(?) things with copper wrapped round them, even though I have the HS on and they are on the other side of the card!. Have you read/heard of anyone removing the heatspreader/plate?. Mines on there quite firmly and I don't relish the thought of ripping the SMT chips off the PCB. I wonder if putting it in the freezer would work like the GPU epoxied on HS used to?...