[fhorst]

Originally Posted by JoshuaPurcell

http://www.koolance.com/products/pro...&category_id=3

Haven't read too much about these HDD coolers but I was thinking of getting two of these to put in between my three HDDs. Not sure if that will be overkill or not though. I'll read up a little more on these.

I'm using 2 of these blocks. I must say they do their job quite good, but I would not stack a raptor on them, they are not that good

One big thing to concider, they are 4.5mm ID.................
In my setup no problem, as I have a seperate loop for my small things (hdd, gpu memory, southbridge, sata chip, memory e.g.) with a seperate pump.

If you are going to place them in your 13mm loop, you are "in trouble". if you split the tubes to 3 times the ID is about the same as 8mm hose (2x 4.5 = 6, 2 x 6 = 8, 2 x 8 = 10, 2 x 10 = 13mm roughly)

As long as you keep that in mind, they are perfect!