Pro/Forums - View Single Post - MagDrive3 Enough for 6'-7' tubing and 226w Pelt?

j3rkoff · 12-29-2003, 09:43 AM

I bought two pumps, and I'm installing both for redundancy...

Anyways, I have a Barton, and my heatercore is one of those big ones (can't find tape measure, I know you can put 6 80mm fans on 1 side). I made a shroud for 2 120mm fans, and the resevoir is fairly big too, maybe holds one liter. I was just wondering if the pumps will run too hot, or is that not something I should worry about w/ the pelt, and will there be enough flow? Tubing is 1/2" ID, no reducers, no T fittings.

Thanks

12-29-2003, 09:43 AM	#1
j3rkoff Cooling Neophyte Join Date: Aug 2003 Location: AZ Posts: 50	MagDrive3 Enough for 6'-7' tubing and 226w Pelt? I bought two pumps, and I'm installing both for redundancy... Anyways, I have a Barton, and my heatercore is one of those big ones (can't find tape measure, I know you can put 6 80mm fans on 1 side). I made a shroud for 2 120mm fans, and the resevoir is fairly big too, maybe holds one liter. I was just wondering if the pumps will run too hot, or is that not something I should worry about w/ the pelt, and will there be enough flow? Tubing is 1/2" ID, no reducers, no T fittings. Thanks