Bah,
Completely missed this thread. Attached is a 3D pic of my Lumpy Channel Block in Solid Works 2003. Here is a pic of the actual base:
Here is my little write up on the block:
http://www.customcooledpc.com/lumpychannel.htm and here is pH's review of the block:
http://www.procooling.com/reviews/ht...lock_revie.php
Note for better performance go with the R-Type block: pH's review
http://www.procooling.com/reviews/ht...rblock_rev.php My write up:
http://www.customcooledpc.com/rtype2.htm