Quote:
Originally posted by bigben2k
Pretty darn close lee! but I'm proposing to direct individual jets to each dimple, to:
a-allow to have fins over the core
and
b-allow the maximum usage of a jet's trajectory
What baseplate thickness did you have in mind?
BTW, Cathar recently revealed (on OC?) that WW's bp thickness is less than 1 mm (!).
|
how are you going to hold down the the top ? if your base plate is too thin and depending on the o-ring and screw placement you could bend the base plate. (i did !). I made the mistake of not cutting the o-ring channle deep enough and maing the hold down screws to close to the edge. when i tighten the screws the edged of the base plate bent.
I am working on a jet for my own wb to spray over the hole cpu area if possible well let you know how progress.
From my 3 stage design i did before i can cut that down to 2 layers buy making the top higher than the fins then making a changable jet plate then will sit directly on top of the fins and also inside the inlet hole of the top. if that make sense.