Quote:
Originally posted by Fixittt
like in the Spir@l, I can pretty much garantee that there is no heat making it to the top of the block. So the clear top is not a problem or a hamper in preformance what so ever.
|
The tops of my blocks don't seem to get hot either. I don't think there is much to worry about there. Once I get time i am going to make a couple of the socket A blocks Brad posted above. I alreadyh started on it, but I need my endmill holder so I can run the 3/8" endmill needed for the channel.
I am going to make a series of different tops. 1 single in/out metal top. One singlee in, dual out metal top and two of the same in acrylic. I will test them all and see what happens. Then I will add the turbulance tothe channel walls and see if that helps any.