Pro/Forums - View Single Post - Two pumps config

#Rotor · 11-07-2002, 03:52 AM

now that core would be ideal for running SMP with.... have the radiator act as the Y split in the loop... then have each split form it's own loop all the way back into the reservoir. IE, have two return fitting in the reservoir as well....

I have not tried the circular pattern yet.... I think you are going to find that cutting away so much copper in between each hole, is going to cost you a little fortune in Dremel Disks. that is why, having the holes in a 90º SQR pattern, gives the best result, the formed pin is concave square with very sharp corners, maximizing the surface area related to its volume... and yet it still has enough "body" to be able to carry substantial amounts of heat out into the pin...

11-07-2002, 03:52 AM	#51
#Rotor Cooling Savant Join Date: Feb 2002 Location: Dione, sector 4s1256 Posts: 852	now that core would be ideal for running SMP with.... have the radiator act as the Y split in the loop... then have each split form it's own loop all the way back into the reservoir. IE, have two return fitting in the reservoir as well.... I have not tried the circular pattern yet.... I think you are going to find that cutting away so much copper in between each hole, is going to cost you a little fortune in Dremel Disks. that is why, having the holes in a 90º SQR pattern, gives the best result, the formed pin is concave square with very sharp corners, maximizing the surface area related to its volume... and yet it still has enough "body" to be able to carry substantial amounts of heat out into the pin... __________________ There is no Spoon.... Last edited by #Rotor; 11-07-2002 at 04:00 AM.