With all this new stuff going on, I need a (another!) reservior. My first one was custom, but I pretty much did not know what I was doing. Now that I am older and wiser... I will do the custom thing again. Most of this to be cut from 1/4" gloss black plexi (same stuff as the base plate of the bezel).
A few hours in SketchUp (yes, a few HOURS - I must get better at this silly program) and this is what we have. I then exported the perspectiveless drawings to DXF and pulled them into Qcad to remove the unneccessary parts and layers and to set the dimensions. I've got to load illustrator on to this machine so I can slap them all on the same sheet, then its off to ben to have them cut.
The res sits vertically despite what the images may have you thinking, the side with the 4 small holes faces inward towards the rest of teh chassis. the long hole is an inspection port and will be backed with 1/8" smoked gray plexi, and backlit from the inside with white LEDs. (ooooh..)
The 4 small holes are for the plug-and-cool G1/4s. The large hole is a 1/2" NPT (3/4") hole for the output to the pump.
Ahhh! an X-Ray!
I've still gotta knock together the mounting rails, but that'll be easy.