Hy Mr. TurboKeu i have connect my asi-c-240128bs-kj-fw lcd to parallel port 25pin but lcdstudio don't work fine. Pin connection are:
1 VSS GROUND
2 VDD POWER (+5V)
3 V0 Power Supply FOR LCD DRIVER
4 C/D H/L WR=L, C/D=H; COMMAND WRITE C/D=L
ATA WRITE
RD=L, C/D=H, STATUS READ C/D=L
ATA READ
5 RD L Data read. Read data from T6963C when RD = L
6 WR L Data write. Write data from T6963C when WR = L
7 DB0 H/L Data bus line
8 DB1 H/L Data bus line
9 DB2 H/L Data bus line
10 DB3 H/L Data bus line
11 DB4 H/L Data bus line
12 DB5 H/L Data bus line
13 DB6 H/L Data bus line
14 DB7 H/L Data bus line
15 CE L L: CHIP ENABLE
16 RESET H/L H: NORMAL; L: INITIALIZE T6963C
17 Vee NEGATIVE VOLTAGE OUTPUT (-16V)
18 MD2 H/L H: 32 COLUMNS; L: 40 COLUMNS
19 FS H/L Pins for selection of font ; H: 6 * 8, L : 8 * 8
20 N.C.
I have not powerlcd can you help me?
thanks