Quote:
Originally Posted by Karantanec
An 1/2" ID tube has an intersection of 127 mm^2
My system uses this intersection surface in every place ( fittings ID, tubing ID, pump ID ), even the radiator allows the water to find its way through so there is always the minimum of 127 mm^2 the water has to overcome at any time...
SO, ideally, the w-block too would have a total inner intersection surface of at least 127 mm^2.
The point? Thats my idea of an unrestricted flow path.
|
a bit to learn about fluid dynamics, you do have.
Quote:
Originally Posted by Karantanec
Perhaps I am crazy
|
nope, just a little mixed up