This would have to be dupliated for all the voltages i asume, but is it really all it takes? Im not the electronics wizard here, so im going to ask straight out, is it possible to swap a few of the components, for lower voltage spec'ed once, and cover all the voltages in a ATX motherboard, and hook it up? How would you have to treat the negative lines? The comon ground, should just be that, comon ground. Might want to add a relay on the power good of each psu aswell, to cut the power completly, and light some status light, if a psu dies.
Am i insane just thinking about it? Just though of it when i read the article, i actually have no idea if it can be done, or how one would go about doing it.
B!