Pro/Forums - View Single Post

pakman · 07-06-2003, 01:31 AM

i know this thread has been dead for a bit, but hats off to airspirit.

I just flushed my system with a pinesol/water mix (readily available in my house). Connected my system to an old milk gallon container full of the pinesol mix (10% pinesol/90% water) and let it run while I watched a video. Came back and 90% of the white film on my tube walls (clearflex 60) and in the waterblocks (dd maze and z-chip) are gone. I've flushed out the pinesol, and am going to do another run with a new mix of pinesol, then flush the pinesol out with just water. tried to take some before and after photos but its dark and the white gunk doesn't show well under the camera flash.

07-06-2003, 01:31 AM	#68
pakman Cooling Neophyte Join Date: Jul 2003 Location: WA State Posts: 76	i know this thread has been dead for a bit, but hats off to airspirit. I just flushed my system with a pinesol/water mix (readily available in my house). Connected my system to an old milk gallon container full of the pinesol mix (10% pinesol/90% water) and let it run while I watched a video. Came back and 90% of the white film on my tube walls (clearflex 60) and in the waterblocks (dd maze and z-chip) are gone. I've flushed out the pinesol, and am going to do another run with a new mix of pinesol, then flush the pinesol out with just water. tried to take some before and after photos but its dark and the white gunk doesn't show well under the camera flash.