Hi all!
Well, I finally started to work on my cube by trying to cut the holes out for the windows using a jigsaw. Well, one hole turned out okay (it's not exactly straight, but it works). But while cutting the other hole, the jigsaw got away from me a little so I ended up cutting out a little chunk that I didn't intend to cut out.
I put the moulding on to see if the rubber would cover up my mistake, but it didn't cover it all.
Soooooo, that's where I need your help!
Could JB weld be used to fill up some of the hole (like 1 - 2 mm)? Any other suggestions are greatly appreciated! I will post pics later.
THANKS!!!!