Just like the topic says. We'll be cooling 10 comps with a 550W pump with 50m max head. Is it enough, we don't know the flow. My friend has to disassamble it cause it's ****ed up with all the shit pumping from his well. It has constand operation written on it. We'll not run the comps 24hr/7. It is just an experiment. We don't need extreme cooling, adequate cooling so we can OC a bit. These are the problems we encountered so far:
Bong tube - what diameter?
Bong tube - what height?
Bong fan - Blower from a car's heater? Is this overkill?
It's cheaper for sure cause we'll steal it
Self refilling res - Will tap water **** everything up. How about catalyst convertors/filters.
Ping pong balls?
Filters for the showerhead...
Manifold? wtf?
The blocks we'll be using are either
squirrel or
this .
The bong will be dissipating a maximum load of 2000watts. We're aiming to keep the water within 5C of ambient.
For each PC, we'll use 1/4" id tubing internally. Is this adequate for a low flowrate? The flow will be split in parallel to all pcs.
Thanks in advance for your comments