my second design
this is the first evolution of a block i am going to make. the first was very high flow.
-this one has been designed to have high flow resistance at a 1" diameter around the inlet point.
-at the outlets i have tried my best to keep things low flow resistance.
-i have kept the atlantis block in mind when designing this. it wouldn't show off the drawing, but atlantis is 2 barb, this is 3 barb so the spiral doesn't have to point one way but two way. (i haven't forgotten , BillA)
i hope the drawings make some sense. anyone who wants to have the source DWG file, pls ask.
the baseplate thickness isn't too important in the drawing, i will try make it as thin as possible around the die area.
__________________
yo soy un tiburón
|