Quote:
|
Originally Posted by unregistered
we have multiple subjects going on (I think ? lol)
if the IHS is loose it solves the wear/maint issue (by replacement)
if the IHS is the die top then there is a problem that may preclude progress
how will one 'know' that the die is flat ?
in ANY case, how is the IHS edge to be supported ?
is the mechanical issue understood ?
put this heat die into a BTX mounting frame
|
About the HS mechanical issue, could it be practical and efficient to use a IHS like this one below and then to secure it in place using the same kind of lever system that Intel has for the socket 775?
