View Single Post
Unread 03-28-2003, 02:41 PM   #7
Cathar's Avatar
Join Date: Sep 2002
Location: Melbourne, Australia
Posts: 2,538

Originally posted by hara
Problem 1: making a 10mm thick copper bar 7mm thick. Any suggestions?

This design lends itself to cathar's WW.

I just need confirmation that the tbred 'B' core is in this orientation:

Thanks for your support!
You can just mill the 10mm thick copper down to 7mm thick if you already have a mill with which to cut your block.

The orientation of the T'Bred B shown in the socket hole picture is correct.

The measurements in the Socket A picture by Aitor are slightly incorrect - they look to be an approximation of the actual measurements. Not bad, but out by up to 0.3mm in places which may be significant for some.

How is the water entering the block? Side to side? Hard to make any suggestions without first knowing that.
Cathar is offline   Reply With Quote