View Single Post
Unread 03-10-2004, 02:31 PM   #27
|kbn|
Cooling Savant
 
|kbn|'s Avatar
 
Join Date: Feb 2004
Location: W. Sussex, UK
Posts: 329
Default

Thanks Butcher, Ive emailed them for a quote for 1/4"x4"x12"

Today I finnished the gpu block. The base is almost perfectly flat, spent about an hour lapping to 1500 grit then I pollished it with silvo. I tryed to take a pic of the finnish but it was too shiny and shows half of my monitor.
It was leak tested under full flow of mains water from bath tap for 5 mins and didnt passed. I might paint the plastic top blue to get rid of the green pen by the barbs. Ill probably put it back on gfx card later this week.
Also a pic of my new heatercore with the old one. Spent the morning cleaning that up.
Attached Images
File Type: jpg finnishedgpuTop.JPG (40.5 KB, 5 views)
File Type: jpg finnishedgpuBottom.JPG (34.9 KB, 3 views)
File Type: jpg finnishedgpuLappedsilverbase1.JPG (36.2 KB, 8 views)
File Type: jpg finnishedgpuLappedsilverbase2.JPG (22.3 KB, 4 views)
File Type: jpg Heatercore2xfan.JPG (42.5 KB, 9 views)

Last edited by |kbn|; 03-15-2004 at 10:10 AM.
|kbn| is offline   Reply With Quote