Intake Turbine from a turbo is driven by engine exhaust,
Now, switch waterflow with engine exhaust on exhaust side to works on the turbine, so fan(will be axial type) attached to intake will rotate and provide some forced convection to radiator.
The velocity of water in the hose will be slow down enough so when it later enter my WB, the pressure(hopefully) no longer 3kg/CM^2, the cross section on my WB design on the inlet side is 20mm*20 fins*0.5mm thickness with 1.5mm between fins, 2CM^2 of contact area getting smack by 3kg/CM^2 will produce 6kg multiplied height of the center of mass amount of torque, which may very well above what my CPU package/socket can handle. So some sort of pressure/velocity reducing devices(such as the watermill fan) must be setup prior to put inside my rig.
|