Pro/Forums - View Single Post

mx · 07-22-2006, 11:46 PM

Okay, I think I'm going with the Swiftech MCP350 (DDC Ultra) and adding the Radiical pump head.
I'm not sure but I don't think that all MCP350's are 18w/Plus/Ultra/red impeller DDC's but only a few because of some mistake. Most of them are standard 10w DDC's (I could be wrong). However I'm pretty sure that Danger Dens DDC's are the newer stronger 18w version.

7/16" ID, I was afraid of compatibility issues.
You can always get small ID tubing on big OD barbs with some hot water and cursing, however it can be hard to get big ID tubing to seal on small barbs.

Do you think the lower CFM will stil be adequate for cooling? Or do you think I should get the Papst fans?
Hard to say, the only way to be sure is to try.

07-22-2006, 11:46 PM	#6
mx Cooling Neophyte Join Date: Oct 2005 Location: Sweden Posts: 73	Re: Final Peltier Setup, Suggestions Anyone? Okay, I think I'm going with the Swiftech MCP350 (DDC Ultra) and adding the Radiical pump head. I'm not sure but I don't think that all MCP350's are 18w/Plus/Ultra/red impeller DDC's but only a few because of some mistake. Most of them are standard 10w DDC's (I could be wrong). However I'm pretty sure that Danger Dens DDC's are the newer stronger 18w version. 7/16" ID, I was afraid of compatibility issues. You can always get small ID tubing on big OD barbs with some hot water and cursing, however it can be hard to get big ID tubing to seal on small barbs. Do you think the lower CFM will stil be adequate for cooling? Or do you think I should get the Papst fans? Hard to say, the only way to be sure is to try.