Lets talk DIY - Presumably, an individual with a small drill bit (3/32"? 1/16"?) some patience, and a drill press could create a reasonable imitation of this sort of pin density and size using the #rotor method, then fabricate the halfmoon and slap a top on. I realize the pins would be diamond-shaped rather than round, but I still think we'd be looking at a new non-CNC DIY performance king. Any thoughts?
EDIT: Added concept drawing
__________________
If not, why not?
Last edited by BalefireX; 05-27-2004 at 07:33 AM.
|