Quote:
Originally posted by hara
The only modification done was changing the channel width from 1.5mm to 2mm and reducing them from 12 to 10.
|
Exactly, do you understand the difference between a 2mm and a 1.5mm end mill?. Not that this person couldn't do it as it apperas he has a very good mill though. I would snap a few 1.5mm endmills if I attempted the original design but I am shure I could do it if I spent a good 6hrs on it. I belive I could also do Bens block aswell given a alot of patients and time. Neither of which I have at the moment.
My impossible statment I will retract.