Quote:
Originally posted by bigben2k
I found 3 references:
but they're all from JayDee116!
|
I posted about it here, sorry no link but it is widely available at any hardware outlet.
In discussion here
A quote from myself,
""Transparent Silicone
Durometer 40A
Tensile Strength, psi 800
Elongation % 250
Get a clear view of your materials through this transparent rubber. Sheets are covered with a protective clear film (remove film before using). Rubber has a temperature range of -80° to +425° F. "
That was straight from the spec sheet of a supplier. It is not impossible to find and goes for about $12.00 per square foot at 1mm thickness. That will get you 24 gaskets at 2" X 3" so I don't see it being a huge cost but rather a cost saver. If you get it adhesive backed, it's a couple dollars more per square foot." end quote
From that discussion you should be able to know what to look for.
Morphling1, don't despair, give up the ship, hang it up, throw in the towel..... there is always room for improvement.
