Quote:
|
I'd file down/cut off some of that copper in the base of the fan part. Preferably so that the bottom two fins have about as much clearance over the WB base as there is space between the fans as you go around the fan.
|
What I intend to do is cut out a rectangular hole in the base of my block and insert the fan into that, then solder seal it, lap ect. the die of my (naked) p4 will directly contact the bottom of the fan, the rest of my block will be there just to direct the water flow, in theory anyway...
I'll make the hole a very tight fit (hopefully) so the plates shouldn't seperate with the heat, (well we'll see
)