Pro/Forums - View Single Post - heat die dimensions

BillA · 10-22-2005, 02:57 PM

re the dwgs:
- set screws on bottom to push up
- use 1" stock for more thickness on bottom (if not copper ?)
- decrease length to 1.25" if 1" cartridges are used
- use two 200W AC heaters

what was/is the basis for your sensor to sensor to face dimensions ?
noting that the 2ed sensor to face dimension will change over time (reworking) if of copper

someone have experience with calorimeters ?
what is the trade-off with 2 sensors vs. 3 ? (2 points a line, 3 a curve - no ?)
Incoherent, have you looked at this ? (did I miss a previous discussion ?)

a material ?
Silicon Carbide, SiC ?? ( some info http://www.accuratus.com/silicar.html)

10-22-2005, 02:57 PM	#5
BillA CoolingWorks Tech Guy Formerly "Unregistered" Join Date: Dec 2000 Location: Posts: 2,371.493,106 Posts: 4,440	re the dwgs: - set screws on bottom to push up - use 1" stock for more thickness on bottom (if not copper ?) - decrease length to 1.25" if 1" cartridges are used - use two 200W AC heaters what was/is the basis for your sensor to sensor to face dimensions ? noting that the 2ed sensor to face dimension will change over time (reworking) if of copper someone have experience with calorimeters ? what is the trade-off with 2 sensors vs. 3 ? (2 points a line, 3 a curve - no ?) Incoherent, have you looked at this ? (did I miss a previous discussion ?) a material ? Silicon Carbide, SiC ?? ( some info http://www.accuratus.com/silicar.html)