These directions worked for me perfectly!!!
1. Create a Win9x boot disk and copy dolly.exe to it.
2. Set up my 2 HDD's on the same IDD channel
3. Make the original 40gb HDD as master and the new 120gb HDD as slave
4. Boot from your diskette.
5. Check the BIOS to ensure it can see both HDD's.
6. Run a:\Dolly xhd128: xhd129:
7. Wait HOURS till you're back at the a:\ prompt
8. Set the jumpers on the 120gb HDD back to master and reinstall to the Snap housing
9. Boot up and "find" the IP address using the Assist program (if you're running DHCP)
10. Browse (http) to
http://ipaddress/config/debug
11. Type in the command box - config devices info
12. You should get a reply on the device # 1000
13. Again type in the command box - config devices format 10000 /reinit
14. Reboot and wait till the new drive has been formatted
15. Bingo ! a nice big Snap drive :-)
What is the BEST 120GB drive to buy??? One that is 5400RPM ATA 100 and Fluid bearings????