Quote:
Originally posted by JFettig
it looks like your taking WAY too much at a time, take less than .5mm with coolant/lube.
also, I think that with just the pins in the center, you can skip the outside fins. if you were to make those holes a little larger(7/64ths) and use a dremel to connect them...
makes life 3000% easier
Jon
|
i know that that would be much much much ... much easier, but if i do not mill the channels, than i am not including any property of my design in the block. what i wanted to test is that if turbulance with high speed water works well as cathar's design and as rotor's design.
just a test
and thank you for the milling suggestion