Quote:
|
Originally Posted by killernoodle
My new mag 3 has developed a rattle of some kind, I think it might be the impellor being loose. I'm going to take it apart and goop the impellor together and see if that might fix the problem, because it is starting to get irritating. I'll post my results tonight.
|
I wouldnt do it... I searched a lot on this before I just went with a 1048. Everyone that did it had to hit their pump to get it to start when they glued the impellar...
And as an FYI on a single block system my 1048 gave me better temps. Too bad I bought that mag3 before I read Cathar's thread on pumps =(
As for what fittings I used a 1/2" pipe threaded nylon T. The actual ID of the threaded fittings is > 3/4". I still used 1/2" ID tubing and fittings at the ends of the T though.