Need advice on DIY water block
I was wondering if it would be possible to make a cascade with a dremel with a router guide to make straight channels. I have everything though out and I don't think it would be to hard to do with the dremel. Also I don't have access to a mill to make an o-ring groove so I was wondering what options I have for make a seal with a polytop that will look good. Also any other suggestions for a waterblock design other then a #rotor. Also my block is 3/4 thick aluminum.
__________________
Its not me!!!!
Last edited by Nightingale; 12-04-2003 at 01:54 AM.
|