Quote:
|
Originally Posted by SnowRider
...But I have just one question....... what if you need to upgrade  ... |
the one heater core (bim2) comes out pretty easy... and the power supply is also not to bad to remove...
cause someone will eventulay ask what do i get for temps and waht is my overclock...
I have a 2.6Ghz CPU overclocked to 3.315 Ghz...
I removed the IHS and i think that helps in the temperatures.
my temperatures run around 33DEGC steady... at max load folding...
unfortuatly I have been having a few leeks...
every few days i pop a hose off one of my 90 or 45 elbows..
and my last time i had a leek i fixed it but i think my zChipset block got jarred.. and isn't connecting properly...
it is a nightmare to get to it.. so i'll look at it his weekend...
right now i'm running stock speeds...
and my temperatures are nice...
Code:
Idle:
CPU:25
MB:30
AIR:24.7
Water:28
Full load:
CPU:30
MB:30
AIR:24.7
Water:29
this is running Sisoft Sandra burn in wizard for 10 min..
the fans are running at 25% power and don't increase in power until they reach 33Deg. which is controlled by the MatrixOrbital MX212
this wekend i'm going to figure out why it won't overclock to the speeds I want...
final note: the temperatures i have obtained may be +/- 1000 Deg.
the CPU temp is obtained from on die temperature probe.
MB temp is obtained... somwhere... not shure where but Motherboard monitor know where it is...
the air temperature is obtained from Matrix Orbital temperature probe
water temperature is a thermalcople sitting in the resevoir pluged into my Motherboard.